Crankshaft Position Sensor: Service and Repair

Crankshaft Position (CKP) Sensor













Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Remove the accessory drive belt.

3. Remove the 3 bolts and position the A/C compressor aside.
- To install, tighten to 25 Nm (18 lb-ft).

4. Disconnect the Crankshaft Position (CKP) sensor electrical connector.

5. Remove the bolt and the CKP sensor.
- To install, tighten to 10 Nm (89 lb-in).

- Lubricate the O-ring seal with clean engine oil prior to installation.

6. To install, reverse the removal procedure.