Functional Test - Safety Belt Retractor
Safety Belt System
WARNING: After any crash, all of the following safety belt assemblies and attaching hardware must be inspected by an authorized dealer to verify correct function:
- Retractors
- Buckles
- Belt tension sensor (BTS) (if equipped)
- Front safety belt buckle support assemblies (slide bar) (if equipped)
- Safety belt shoulder belt height adjusters (if equipped)
- Child safety seat tether bracket assemblies
- Automatic locking retractor (ALR) feature for child safety seats (passenger seating positions only)
If any safety belt assembly is damaged, does not operate correctly or does not pass all of the Functional Tests in the Diagnosis and Testing, a new safety belt assembly must be installed. If any safety belt assembly attaching areas are damaged or distorted, the sheet metal must be restored to its original structural integrity and new safety belt assembly and attaching hardware must be installed. Failure to install new safety belt assemblies and attaching hardware may increase the risk of serious personal injury or death in a crash.
After any crash that results in deployment of the driver and/or front outboard passenger safety belt pretensioners, new driver and/or front outboard passenger safety belt systems (including retractors, buckles and height adjusters) must be installed. Failure to install new safety belt systems increases the risk of serious personal injury or death in a crash.
Component Test
Carry out the appropriate Functional Test(s) as determined in Inspection and Verification.
Functional Test - Safety Belt Retractor
The safety belt retractor must be freely operational for extraction and retraction of the safety belt webbing between full extension and in-vehicle stowed positions.
1. Extract and retract the safety belt between the full extension and stowed positions.
2. Verify the safety belt retractor operates without excessive effort or binding.
3. Install a new safety belt retractor if any concern is found or the complaint has been verified.