Seat Backrest - Rear, Bucket

Seat Backrest - Rear, Bucket

Removal and Installation

NOTE: For parts identification and locations, refer to Seat - Exploded View, Rear, Bucket Seat - Exploded View, Rear, Bucket.

1. Insert an appropriate tool into the slot and release the detachable safety belt anchor from the seat.





2. Remove the seat.
- Pull the seat latch release handle, slide the seat to the right and disengage from the seat latch striker.






3. Remove the bolt and detachable safety belt anchor.
- To install, tighten to 40 Nm (30 lb-ft).

- Remove the locator spacer.
- Note spacer position for correct installation.



4. Remove the RH armrest. For additional information, refer to Seat Armrest- Rear, Bucket Seat Armrest - Rear, Bucket.

5. If equipped, remove the 3 screws and LH cushion side shield.

6. Remove the backrest pivot bolt.
- To install, tighten to 25 Nm (18 lb-ft).


7. WARNING: Use care when the seat back frame is removed and when releasing the recliners from a backrest upright position. The recliners are spring-loaded, which may cause the recliner upper arms to fold with significant speed/force. Failure to follow this instruction may result in serious personal injury.

Remove the 2 backrest-to-recliner bolts.
- To install, tighten to 48 Nm (35 lb-ft).


8. Lift and slide the backrest from the recliner and remove.

9. To install, reverse the removal procedure.