5000 MI or 8000 KM

Inspect
    Wheels
      Inspect wheels and related components for abnormal noise, wear, looseness or drag. If using Special Operating Conditions, T, I, D, O.
    Universal Joint, Drive/Propeller Shaft
      Inspect and lubricate U-joint if equipped with grease fittings, if using Special Operating Conditions T, I, D or O.
    Steering and Suspension
      Inspect and lubricate steering linkage if equipped with grease fittings, if using Special Operating Condition O. Inspect and lubricate control arm and steering ball joints if equipped with grease fittings, if using Special Operating Condition I.
    Brakes and Traction Control
      Inspect brake system if using Special Operating Condition I.
    Ball Joint
      Inspect and lubricate ball joints if equipped with grease fittings, if using Special Operating Condition O.
    Air Filter Element
      Inspect engine air filter and service as required if using Special Operating Conditions I, D or O.
Replace
    Oil Filter, Engine
      Change engine oil every 5,000 miles or 6 months if using Special Operating Conditions T, D, O, E. Change engine oil every 5,000 miles or 6 months or 200 hours of engine operation if using Special Operating Conditions I.
    Engine Oil
      Change engine oil every 5,000 miles or 6 months if using Special Operating Conditions T, D, O, E. Change engine oil every 5,000 miles or 6 months or 200 hours of engine operation if using Special Operating Conditions I.
Rotate
    Tires
      Rotate tires, inspect tires for wear, measure tread depth and inspect wheel ends for end play and noise. Vehicles with dual rear wheels should only rotate if unusual wear is noted. For vehicles with different front-to-rear tire pressures, the tire pressure must be adjusted and the tire pressure sensor training must be done. If using Special Operating Conditions T, I, D, O or E.