Inspection and Verification

Safety Belt System

Inspection and Verification

1. Verify the customer's concern by operating the active restraint system to duplicate the condition.

2. Inspect to determine if any of the following mechanical or electrical concerns apply:

Visual Inspection Chart






3. If the inspection reveals an obvious concern(s) that can be readily identified, service as required. With the exception of removing a twist from the safety belt webbing, do not attempt to repair a component of the safety belt system; new components must be installed.

4. If the concern remains after the inspection, determine the symptom. GO to Symptom Chart. Symptom Related Diagnostic Procedures

5. To check the active restraint system for correct operation, carry out the appropriate Functional Test(s). Component Tests and General Diagnostics