DS III

Ignition System Schematic:

The Ignition Module shuts off the primary circuit each time it receives a pulse from the EEC III Microprocessor Fig. 2. A timing circuit in the ignition module turns the primary current back on after a short period of time. High voltage is created each time the magnetic field is built up and collapsed. The red ignition module wire provides operating voltage for the module's electronic components in the Run mode. The white module wire and start bypass provide increased voltage for the module and coil during Start mode.

Module Identification Chart:

For proper ignition module identification refer to Fig. 1. The modules are not interchangeable, Dura Spark II has 6 wire connector while Dura Spark III has a 5 wire connector.