Engine - Overheating Concern
83ford10Article No. 83-16-19
DIESEL (6.9L) - ENGINE OVERHEAT
- CRANKCASE BLOCKAGE
LIGHT TRUCKS 1983 E & F SERIES
FIGURE 27:
An engine overheating condition may be caused by blockage of the upper cooling passage in the crankcase (Figure 27). To check for blockage, perform the following steps:
^ Remove the thermostat, thermostat housing and temperature sending unit from the crankcase.
^ Using a flexible 18 inch long wire, probe the cooling passage from either the thermostat opening or temperature sending unit opening.
^ If the wire strikes an obstruction, the passageway is blocked. If the wire goes through, the passageway is open.
In most cases the obstruction can be removed by hitting it with a punch. It may be necessary to remove the heads to do this.
However, should the obstructions be too thick to break, replace the block assembly.
OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: Reimbursable within the provisions of the Warranty and Policy Manual.
OPERATION: M
TIME: "Actual Time" as defined in the Warranty and Policy Manual. DLR. CODING: Basic Part No. 6010 Code: 55