Removal and Installation

1. Raise and support vehicle.
2. Support engine with a suitable jack and a wooden block positioned under oil pan.
3. Drain transmission fluid by removing lower extension housing to transmission bolt.
4. Disconnect gearshift linkage and speedometer cable from transmission.
5. Disconnect back-up light electrical connector.
6. Disconnect driveshaft from transmission and position aside.
7. Raise transmission and remove rear support, the insulator and retainer assembly.
8. Remove transmission to flywheel attaching bolts.
9. Slide transmission rearward until input shaft clears clutch housing, then carefully lower transmission from vehicle.

NOTE: Do not depress clutch pedal with transmission out of vehicle.

10. Reverse procedure to install.