Servo Apply Lever

Servo Apply Lever

Disassembly






1. Working from inside of the transmission case, carefully drive on the servo apply lever shaft to remove the cup plug. The shaft (Fig. 34) can be withdrawn from the case by hand.

Assembly

1. Hold the servo apply lever in position and install the new shaft.






2. Using the fabricated tool shown in Fig. 34, drive the cup plug into position in the case. Be sure the plug is flush with the shoulder of the counterbore. The cup plug may be coated with Threadlock and Sealer, EOAZ-19554-A (ESE-M-204-A) or equivalent, before installation.