Shift Linkage: Adjustments
Fig. 1 Floor Shift Control Linkage:
Ensure that shift lever detent pawl is held against rearward Drive detent stop during linkage adjustment procedure.
1. Position transmission selector control lever in the D position and loosen trunnion bolt, Fig. 1. Do not use overdrive position.
2. Position transmission manual lever in D range by moving bellcrank lever all the way rearward, then forward four detents.
3. With transmission selector lever and manual lever in D position, apply light forward pressure to shifter control lower arm while torquing trunnion bolt to 13-23 ft. lbs.
4. Check for engagement in P. Control lever must move to right when engaged in P detent. Check transmission control lever in all detent positions with engine running to ensure correct detent/transmission action, readjusting as necessary.