Window Regulator

Removal






1. Remove door trim panel and watershield. Doors
2. Prop glass in full-up position.
3. Remove four rivets attaching regulator plate to door inner panel. Remove center pin from each rivet with a drift punch. Drill out the remainder of rivet using a 6.35mm (1/4-inch) diameter drill. Use care not to enlarge sheet metal retaining holes.
4. Remove nut and washer, and screw and washer attaching regulator tube to inner panel and doorsill. Slide tube up into door belt, adjacent.to the glass.
5. Remove window regulator from door through large access hole.

Installation

1. Position glass in full-up position.
2. Install window regulator through access hole in door and insert arm slide/roller into glass bracket C-channel.
3. Slide regulator tube assembly down into position in door and loosely assemble retainers with nut and washer, and screw and washer assemblies.
4. Install four rivets to secure regulator mounting plate to door inner panel.
5. Tighten nut and washer, and screw and washer assemblies to secure regulator tube.
6. Cycle glass to ensure smooth operation.
7. Install door watershield and trim panel.