Ignition Control Module: Service and Repair

1. Remove two screws retaining TFI/heat sink assembly to lefthand fender apron.
2. Disconnect harness connector, then remove two screws retaining TFI module to heatsink. Remove TFI module.
3. Coat metal base plate of TFI ignition module with 1/32 inch thick layer of silicone grease.
4. Install module on heatsink, then Torque two retaining screws to 15-35 inch lbs.
5. Install TFI/heatsink assembly to lefthand fender apron using two retaining screws.
6. Connect harness connector.