Pages 17-09-89 & 17-09-90

1989
17-09-89 E40D Automatic Transmission 17-09-89




DISASSEMBLY AND ASSEMBLY (Continued)

51. Place gasket on extension housing.

NOTE: Care should be taken to ensure that the parking pawl return spring is properly located on the inside surface of the case, when installing the extension housing. This spring must NOT be trapped on the sealing surfaces between the extension and case.




52. Install extension housing and wiring bracket on rear of case using nine bolts (13 mm socket). Tighten bolts to 27-39 N-m (20-29 ft.lbs.).

NOTE: The two bottom bolts are longer on 4 x 4 vehicles.




53. Rotate transmission so that pan surface is facing up. Install one steel and ten rubber check balls, EPC blow-off spring and ball into case pockets.

NOTE: Refer to illustration.

1989
17-09-90 E40D Automatic Transmission 17-09-90




DISASSEMBLY AND ASSEMBLY (Continued)

54. Install case-to-separator plate gasket.




55. Install separator plate.




56. Attach reinforcing plate with three bolts (8 mm socket) with stamped "up" facing up. Tighten to 9-11 N-m (80-100 in.lbs.).

NOTE: Check placement of EPC blow-off ball.




57. Install new separator-to-control gasket.