Ignition Lock: Service and Repair

1. On models equipped with airbag, disarm airbag system as described under Air Bags and Seat Belts/Air Bags (Supplemental Restraint Systems)/Service and Repair/Airbag System Disarming.
2. On all models, disconnect battery ground cable and isolate with electrical tape.
3. On models with tilt steering column, remove upper extension shroud. Unsnap shroud from retaining clip located at the 9 o'clock position.
4. On all models, remove trim shroud or shroud halves, then disconnect key warning switch electrical connector.
5. Place gear shift lever in PARK on models with automatic trans. or in any gear on models with manual trans.
6. Insert a 1/8 inch diameter pin in the hole in casting surrounding lock cylinder. Pull lock cylinder out of housing while depressing retaining pin.
7. To install, turn lock cylinder to RUN position and depress retaining pin.
8. Install lock cylinder into housing. Turn key to OFF position after checking that cylinder is fully seated and aligned in the interlocking washer.
9. Turn the key to check for proper operation in all positions.
10. Install trim shroud and extension shroud if applicable.
11. Reconnect battery ground cable.
12. Reactivate airbag system.