Cruise Control Switch: Service and Repair

1. Remove steering wheel pad attaching screws from behind steering wheel.
2. While pulling pad away from steering wheel, disconnect horn and speed control wire connectors and remove pad.
3. Remove retaining nuts securing the speed control switches and trim plate retainer to the steering wheel pad.
4. Disconnect wiring connector on rear of steering wheel pad assembly, then remove switch and trim retainer assembly.
5. Remove speed control switches by snapping out of plastic retainer.
6. To remove the ground brush, remove steering wheel for access.
7. Snap the ground brush assembly out of the turn signal switch.
8. Reverse procedure to install.