Rear Antilock Brake System Sensor (F-150 and Bronco Only)

1. If new sensor is to be instal led, lightly lubricate 0-ring with motor oil.

a. Firmly grasp sensor at sides (do not install by applying force on connector) and push into axle housing, aligning mounting flange hole with threaded hole in axle housing.

b. Install hold down bolt and;tighten to 34-41 Nm (25-30 ft-lb).

2. If old sensor is to be reinstalled, clean and blow off metal particles using shop air.

a. Remove and replace 0-ring with a new 0-ring.

b. Apply a light film of motor oil to 0-ring.

c. Firmly grasp sensor at sides (do not install by applying force on connector) and push into axle housing, aligning mounting flange hole with threaded hole in axle housing.

Sensor Installation:

d. Install hold down bolt and tighten to 34-41 Nm (25-30 ft-lb).