Intermediate Band Servo - With E4OD

REMOVAL
1. Disconnect battery ground cable.
2. Raise and support vehicle.
3. Loosen oil pan attaching bolts and drain fluid from transmission, then remove attaching bolts and pan.
4. Remove filter and gasket.
5. Remove accumulator body and main control body attaching bolts.

Removing Main Control Body:

NOTE: Do not remove two bolts, as shown in the Removing Main Control Body image, from main control body.

6. Remove solenoid body attaching bolts. Remove solenoid body by pushing down on solenoid body receptacle.

Removing Solenoid Screen:

7. Remove solenoid screen by turning counterclockwise and pulling out, as shown in the Removing Solenoid Screen image.
8. Remove three reinforcing plate attaching bolts, then the plate.

Removing Separator Plate And Gaskets:

9. Carefully lower separator plate and gasket so check balls, Electronic Pressure Control (EPC) ball, and spring are retained.

Removing Intermediate Band Servo Assembly:

10. Remove servo snap ring and retaining plate, piston, rod assembly, and servo spring.

INSTALLATION
1. Reverse procedure to install, noting the following:

Fig. 13 Check Ball Location (Units W/9 Rubber Check Balls):

Fig. 12 Check Ball Location (Units W/10 Rubber Check Balls And 1 Steel Check Ball):

a. Ensure same number of check balls, EPC ball and spring are in proper position.
b. Torque reinforcing plate, main control body, accumulator body, and solenoid body attaching bolts to 80-100 in lbs.
c. Torque pan bolts to 10-12 ft lbs.