Overdrive Clutch

OVERDRIVE RING GEAR AND CENTER SHAFT - WITH E4OD

REMOVAL

Overdrive Ring Gear And Center Shaft Exploded View:

NOTE: Refer to the Overdrive Ring Gear And Center Shaft Exploded View image when performing the following procedure.

1. Remove inner race.
2. Remove small (inner) snap ring and one-way clutch assembly.
3. Remove large snap ring, the outer race assembly from ring gear.
4. Remove thrust washer No. 7G400 from front of carrier.
5. Remove overdrive carrier from ring gear assembly.
6. Remove needle bearing assembly No. 7G128 from rear face of overdrive carrier.
7. Remove center shaft to ring gear wave-type snap ring, then the center shaft from ring gear.

INSTALLATION
1. Reverse procedure to install, noting the following:
a. Outer race assembly snap ring groove must be facing up.

Installing One-Way Clutch:

b. One-way clutch must be installed as shown in the Installing One-Way Clutch image.
c. Inner race must rotate counterclockwise.