With C6

REMOVAL
1. Raise car on hoist or jack stands.
2. Loosen and remove all but two oil pan bolts from front of case and drop rear edge of pan to drain fluid.
3. Remove and clean pan and screen.
4. Remove and discard the nylon shipping plug from the filler tube hole.
5. Unfasten and remove valve body.

INSTALLATION
1. Position valve body to case, making sure that selector and downshift levers are engaged, then install and torque attaching bolts to 95-125 in lbs.
2. Using new pan gasket, secure pan to case and torque bolts to 8-12 ft lbs.
3. Lower car and fill transmission to the correct level with specified fluid.