Fuel Sender Assemblies - Now Available For Service

90ford07

FUEL SYSTEM - FUEL TANK - SENDER AVAILABLE FOR SERVICE

Article No. 90-7-18

LIGHT TRUCK: 1989-90 BRONCO II 1990 BRONCO, F-150, F-250, F-350

ISSUE: Fuel sender assemblies are now available for service. If fuel indicating system diagnostics indicate that a fuel sender is defective, it is not necessary to replace the complete (9H307) pump/sender assembly.

Figure 1:

ACTION: Install a fuel pre-calibrated sender assembly. Attach it with two screws in the reservoir case, Figure 1. Refer to the following Fuel Sender Resistor/Case/Float Rod Assembly Application Chart for correct parts usage.




NOTE: THESE SERVICE UNITS SHOULD BE USED UNLESS A DEFECTIVE FUEL PUMP IS DIAGNOSED. IN THAT CASE, THE ENTIRE PUMP/SENDER ASSEMBLY (9H307) SHOULD BE REPLACED.

OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: Eligible Under Basic Warranty Coverage
OPERATION DESCRIPTION TIME
900718A All Others 1.4 Hrs.
900718A Bronco II 1.5 Hrs.
900718A F-Series - 18.0 Gallon Rear 1.7 Hrs.
Tank
DEALER CODING
BASIC PART NO. CONDITION CODE
9A299 42
OASIS CODES: 2300, 2310, 4500