Installation

1. Raise vehicle on a hoist or a jack and position left hand axle assembly at leaf spring assembly. Install the pivot bolt that secures the axle assembly to the crossmember. Secure the shock absorber mounting plate to the leaf spring and axle assembly with the two U-bolts. Tighten bolts to 116-162 Nm (85-120 ft-lbs).

2. Position the right hand axle assembly at crossmember. Install the boot on the shaft so the boot seats in the grooves. Position new keystone Clamps over the grooves on the boot and crimp the clamp with Keystone Clamp Pliers, T63P-9171-A or equivalent. Align the axle shaft and install in slip shaft. Install the pivot bolt that secures the axle assembly to crossmember. Tighten bolt to 123-203 Nm (120-150 ft-lbs). Install shock absorber mounting plate, leaf spring and axle assembly using two U-bolts. Tighten bolts to 116-162 Nm (85-120 ft-lbs).

3. Install vent fitting to differential housing and connect vent tube to vent using a new hose clamp.

4. Connect the steering linkage.

5. Install brake caliper and wheel and tire assembly.

6. Check and adjust caster, camber and toe-in.