Removal and Replacement

Intake Manifold:

REMOVAL

1. Disconnect Air Bypass Valve Assembly connector from the wiring harness.
2. Remove two Air bypass valve retaining screws.
3. Remove air Bypass Valve and gasket.
NOTE: If scraping is necessary, be careful not to damage air bypass valve or throttle body gasket surfaces, or drop material into throttle body.

INSTALLATION

1. Ensure that both intake manifold and air bypass valve gasket surfaces are clean.
2. Install gasket on intake manifold surface and mount air bypass valve assembly, securing it with two retaining screws. Tighten to 71-97 lb. in. (8-11 N-m).
3. Connect electrical connector for Air Bypass Valve.