Rear

Rear:

Rear:

Removal

1. Remove door trim panel and watershield. Doors

2. Remove inner belt weatherstrip.

3. Remove door glass.

4. Remove door garnish moulding.

5. Remove run retaining screws.

6. Remove door glass run assembly.


Installation

1. Install run channel assembly into door frame.

2. Push run channel onto door flange starting at upper C-pillar corner.

3. Continue down C-pillar and then across top of door frame and down B-pillar.

4. Install glass run retaining screw and washer assemblies. Tighten to 9-14 N-m (7-10 lb-ft).

5. Install door garnish moulding.

6. Install door glass.

7. Install inner belt weatherstrip.

8. Adjust door glass.

9. Install watershield and trim panel. Doors