Electronic Brake Control Module: Service and Repair

RABS System Components:

Item Part Number Description
1. 2264 Front Brake Tube
2. 2B373 Anti-Lock Brake Control Module
3. 2A040 Brake Master Cylinder Connector Tube
4. 2916 Tube Assembly, Control Valve, Front
5. 4010 Rear Axle Housing
6. 2L373 Speed Sensor
7. 4B409 Speed Sensor Ring
8. -- Speed Sensor Test Connector (Part of 14290)
9. 11572 Ignition Switch
10. -- RABS KAM Diagnostic Connector (Part of 14290)
11. 2C018 Anti-Lock Electronic Control Unit

RABS Control Module:

REMOVAL
1. Disconnect the wiring harness from the RABS II connector by depressing the plastic tab on the connector and pulling the connector off.
2. Remove the two nuts that retain the anti-lock electronic control unit to the instrument panel anti-shake brace.
3. Remove the anti-lock electronic control unit from the anti-shake brace.

INSTALLATION
1. Position the anti-lock electronic control unit on the anti-shake brace.
2. Install the two nuts that hold the anti-lock electronic control unit to the anti-shake brace.
3. Connect the wiring harness to the anti-lock electronic control unit.
4. Check the system for proper operation.