Operation CHARM: Car repair manuals for everyone.

G2 Check Valve Coil



- Disconnect 8-pin valve block connector.

- Verify terminals on both halves of the valve block 8-way connector are clean and secure.

- Measure resistance between Pins 1 and 3 and Pins 4 and 3 on the valve block.

- Are both readings between 3 and 6 ohms?

YES -- Remove main relay. Service open or short to ground in Circuits 510 (T/R) or 532 (O/Y) between valve block harness connector and ECU connector. Install relay. Go to G4. G4 Check For DTC Repeatability

NO -- Replace valve block. Go to G4. G4 Check For DTC Repeatability