Vacuum Pump Switch: Service and Repair

Vacuum Hose Routing:

Low Vacuum Switch:

NOTE: The distributor modulator valve switch is mounted to the left side fender panel.

REMOVAL
1. Disconnect vacuum hose from distributor modulator valve switch.
2. Remove two attaching screws and remove distributor modulator valve switch and A/C compressor mounting bracket (2882).

INSTALLATION
1. Position distributor modulator valve switch and A/C compressor mounting bracket to panel and secure with two screws. Tighten screws to 8-11 Nm (6-8 ft lb).
2. Connect vacuum hose to distributor modulator valve switch.