1997-98 Expedition/F-150/250 LD 4X4 Frnt. Bumper
1997-98 EXPEDITION AND F-150/250 LD 4X4 FRONT BUMPER1. Turn off air suspension if applicable.
2. Hoist vehicle until bumper is at working level.
3. Remove the fog lamps or fog lamp blanks.
4. Mask the front face of the center at air opening and both fog lamp openings (Figure 1).
5. Disconnect fog lamp wiring and block heater wires from the bumper.
6. Disconnect the three (3) push pins for the splash guard.
7. Clean excessive dirt from inside and outside the bumper.
8. Spray the edges of the three (3) openings with Super Seal Anti-Corrosion Compound.
9. Remove the tape from the fog lamp openings so as not to get the Super Seal Anti-Corrosion Compound on the fog lamps during reinstallation.
10. Reinstall the fog lamps/fog lamp blanks.
11. Plug in fog lamp wiring and push pins for the block heater connector and lower valance push pins.
12. Lower vehicle and turn on air suspension if so equipped.
13. Clean vent and fog lamp openings as needed.