DH11 - Check TP Circuit For Shorts to SIG RTN or PWR GND
- Key Off.
- TP sensor disconnected.
- Breakout box installed.
- PCM disconnected.
- Measure the resistance between Test Pin 89 (TP SIG) and Test Pins 91 (SIG RTN) and 24 or 103 (PWR GND) at the breakout box.
- Is each resistance greater than 10,000 ohms?
YES -- TP SIG open or shorted to SIG RTN (or PWR GND) in the PCM. REPLACE PCM. REMOVE breakout box. RECONNECT all components. Rerun quick test. Diagnostic Subroutines (DSR) - Extracting Codes
NO -- SERVICE TP SIG shorted to SIG RTN (or PWR GND) in the harness. REMOVE breakout box. RECONNECT all components. Rerun quick test. Diagnostic Subroutines (DSR) - Extracting Codes