H84 - Check HO2S Circuit Continuity
- Key Off.
- PCM connected.
- Suspect HO2S disconnected.
- Jumper HO2S Signal to VPWR at the HO2S harness connector.
- Scan Tool connected.
- Key On, Engine Off.
Heated Oxygen Sensor Codes And Test Pins:
- Access the correct HO2S PID.
NOTE: (HO2S displayed as O2S on Scan Tool.)
- Is the voltage reading greater than 3.50 volts?
YES -- REPLACE HO2S. COMPLETE PCM reset to clear DTCs. Clearing Diagnostic Trouble Codes
COMPLETE a HO2S Monitor Drive Cycle. Monitors, Trips, Drive Cycles and Readiness Codes
NO -- GO to H85. H85 - Check HO2S Harness Circuit For Short to VPWR and Ground