HV10 - Check VPWR Circuit Voltage
- Key On, Engine Off.
- CANP solenoid disconnected.
- Measure the voltage between VPWR at the CANP solenoid vehicle harness connector and battery ground.
- Is the voltage greater than 10.5 volts?
YES -- VPWR circuit is OK. Go to HV11. HV11 - Check CANP SIG Harness Continuity
NO -- SERVICE open in VPWR circuit. RECONNECT CANP solenoid. Rerun quick test. Diagnostic Subroutines (DSR) - Extracting Codes