JC60 - Check For C2 Short Low - Coil Disconnected

- Key Off.

- DVOM 20K ohm scale.

- Disconnect coil from coil tee, leave EI diagnostic harness connected to vehicle harness coil connector.

- Measure resistance between J7 (B-) and J6 (RC2C) at breakout box.

- Is resistance reading less than 2K ohms?

YES -- GO to JC61. JC61 - Check For C2 Short Low - ICM and Coil Disconnected

NO -- REPLACE Right Coil Pack. C2 open in coil. REMOVE all test equipment. RECONNECT all components. Clear continuous memory. Clearing Diagnostic Trouble Codes

Rerun quick test. Diagnostic Subroutines (DSR) - Extracting Codes