QA11 - Check Bus(+) Circuit For Short to Power
*** THIS ARTICLE REFLECTS CHANGES MADE BY TSB # 9326B6, December 1993
- Key Off.
- Breakout box installed, PCM disconnected.
- Key On, Engine Off.
- Measure voltage between Test Pin 16 [BUS (+)] and Test Pin 51 or 103 (PWR GND) at the breakout box.
- Was the voltage greater than 1.0 volt?
YES -- SERVICE short to power in the BUS(+) circuit. RECONNECT the PCM. REMOVE breakout box. Rerun quick test. Diagnostic Subroutines (DSR) - Extracting Codes
NO -- REPLACE the PCM. REMOVE breakout box. Rerun quick test. Diagnostic Subroutines (DSR) - Extracting Codes