TC3 - Check Continuity of Solenoid and VPWR Harness Circuit
- Key Off.
- Disconnect PCM. Inspect for damaged or pushed out pins, corrosion, loose wires, etc. Service as necessary.
- Install breakout box, leave PCM disconnected.
- Measure resistance between the VPWR pins at the transmission vehicle harness connector and Test Pin 71/97 at the breakout box.
- Measure resistance between the suspect solenoid signal pin at the vehicle harness connector and the same suspect solenoid signal pin at the breakout box.
- Is each resistance less than 5.0 ohms?
YES -- GO to TC4. TC4 - Check Solenoid Circuit For Short
NO -- SERVICE open circuit. REMOVE breakout box. RECONNECT all components. Rerun quick test. Diagnostic Subroutines (DSR) - Extracting Codes