TG140 - Remaining DTCs For Electronic Transmissions

Continuous Memory DTC 0731 indicates an incorrect gear ratio after first gear was commanded.

Continuous Memory DTC 0732 indicates an incorrect gear ratio after second gear was commanded.

Continuous Memory DTC 0733 indicates an incorrect gear ratio after third gear was commanded.

Continuous Memory DTC 0734 indicates an incorrect gear ratio after fourth gear was commanded.

Continuous Memory DTC 0735 indicates an incorrect gear ratio after fifth gear was commanded.

Continuous Memory DTC 0751 indicates shift solenoid # 1 not performing mechanically as expected.

Continuous Memory DTC 0756 indicates shift solenoid #2 not performing mechanically as expected.

Continuous Memory DTC 1731 indicates an improper 1-2 shift.

Continuous Memory DTC 1732 indicates an improper 2-3 shift.

Continuous Memory DTC 1733 indicates an improper 3-4 shift.

Continuous Memory DTC 1734 indicates an improper 4-5 shift.

Continuous Memory DTC 1786 indicates a 3-2 downshift error.

Continuous Memory DTC 1787 indicates a 2-1 downshift error.

Possible Causes:
- Intermittent harness continuity.
- Damaged shift solenoid.
- Worn friction elements.

- Key Off.

- Disconnect PCM. Inspect for damaged or pushed out pins, corrosion, loose wires, etc. Service as necessary.

- Install breakout box, connect PCM.

- Connect one DVOM test lead to the shift solenoid signal Test Pin (Pin 27 when concerned with SS1 and Pin 1 when concerned with SS2) and the remaining DVOM test lead to Test Pin 71 (VPWR).

- Key On, Engine Off.

- Observe the DVOM for an indication of a fault while performing the following:
- Wiggle, shake and bend a small section of the PCM vehicle harness while working toward the dash panel, PCM and transmission connectors.

NOTE: A fault is indicated by a sudden voltage change?

- Is a fault Indicated?

YES -- ISOLATE fault and SERVICE as necessary. Complete PCM reset to clear DTCs. Clearing Diagnostic Trouble Codes

Rerun drive cycle test in TG90 to verify the repair. TG90 - Perform Drive Cycle Test

If concern still exists, REFER to Transmission and Drivetrain/Automatic Transmission/Transaxle for possible internal transmission damage.

NO -- COMPLETE PCM reset to clear DTCs. Clearing Diagnostic Trouble Codes

GO to Transmission and Drivetrain/Automatic Transmission/Transaxle for possible internal transmission damage.