Installation

1. Install the rear disc brake caliper onto the guide pin. Pivot the rear disc brake caliper over the rear disc brake caliper anchor plate.
2. Grease and install the brake caliper bolt. Use Disc Brake Caliper Slide Grease D7AZ-1950-A (ESA-M1C172-A) or equivalent. Tighten the brake caliper bolt to 34-39 N-m (25-29 lb-ft).
3. Install two new copper washers on the rear wheel brake hose banjo fitting.
4. Position the connector bolt and the rear wheel brake hose on the rear disc brake caliper. Tighten the connector bolt to 23-29 N-m (16-22 lb-ft).
5. Position the parking brake rear cable and conduit into the rear brake operating lever and the rear disc support bracket. Install the parking brake rear cable and conduit retaining clip.
6. Adjust the parking brake rear cable and conduit so there is NO clearance between the parking brake rear cable and conduit end and the rear brake operating lever.
7. Tighten the parking brake rear cable and conduit adjusting nut.
8. Bleed the rear brakes either manually or with Rotunda Pressure Bleeder 104-00064 or equivalent. Refer to Brake Bleeding.
9. Install the wheel. Tighten the wheel hub bolt nuts to 88-118 N-m (65-87 lb-ft).