NB4 - Check IDM Circuit For Short to Power (Excluding VREF)
- Key "OFF".
- Breakout box installed.
- Powertrain Control Module (PCM) and Ignition Control Module (ICM) (Pins 1-6) disconnected.
- "Key On".
- Measure voltage between test pin 4 and test pin 40 or 60 at the breakout box.
- Is voltage reading greater than 10.5 volts?
Yes -- Service short circuit. Remove breakout box. Reconnect all components. Rerun quick test. Quick Test Appendix (Detailed Testing Instructions)
No -- Go to NB5. NB5 - Check IDM Circuit For Shorts to VREF and PIP