Ignition Coil: Service and Repair

REMOVAL

1. Disconnect spark plug wires from ignition coil by squeezing the locking tabs on wire retainer by hand and using a twisting and pulling motion to free boot from terminal. Do not pull on the wire.
2. Disconnect engine harness electrical connector from ignition coil.
3. Remove four ignition coil assembly retaining screws, then the coil. On vehicles with power steering, it may be necessary to remove lefthand (intake) coil and bracket as an assembly.

INSTALLATION

1. Mount ignition coil to bracket, tightening four retaining screws to 40-62 lb. in. (4.5-7.0 N-m).
2. Connect engine harness electrical connector to ignition coil.
3. Install spark plug wires.