Safety Belt With Anchor Plate Thread Damage

1. Remove the broken or stripped bolt and discard.
2. Drill out the internal threads in the safety belt anchor plate with a 27/64-inch drill.
3. Rethread the anchor plate with a 1/2-13 tap (seat belt).
4. Blow out the chips.
5. Install the attachment parts in the order shown, whichever is applicable. Tighten the replacement bolt to 30-40 N.m (22-30 ft-lb). Original parts are to be replaced with the repair parts. Unless specified in the guides, use original parts.
6. When repairing a multiple belt and attachment, install nut to the bolt in the tunnel area from the underside of the floorpan. Tighten to specification 30-40 N.m (22-30 ft-lb).