Manufacturer Code Charts: 6: 6.1

Connector Diagram:

- Turn ignition OFF.

- Disconnect battery ground cable.

- Remove the module connector.

- Inspect module component connector for contamination and loose or bent terminals.

- Pull gently on Circuit 519 (LG/BK) just behind Pin 3 on the harness connector.

- Pull gently on Circuit 523 (R/PK) just behind Pin 10 on the harness connector.

- Are connections clean and secure?

YES -- Leave module connector disconnected. Go to 6.2. 6.2

NO -- Terminal(s) in ABS Module connector are corroded, bent, or loose. Service terminals or connector as needed. If not serviceable replace anti-lock electronic control module. GO to 6.7. 6.7

Terminal(s) in harness connector are corroded, bent, or move back or come free of connector. Service terminals or connector as needed. GO to 6.7. 6.7