Manufacturer Code Charts: 6: 6.2

- Verify ignition is OFF.

- Remove Speed Sensor connector.

- Inspect sensor component connector for contamination and bent or loose terminals.

- Gently pull on Circuit 519 (LG/BK) behind Pin B of harness connector.

- Gently pull on Circuit 523 (R/PK) behind Pin A of harness connector.

- Are connections clean and secure?

YES -- Reinstall RABS Speed Sensor connector. Go to 6.3. 6.3

NO -- Service terminal or connector as needed. If not serviceable, Replace RABS sensor. Go to 6.7. 6.7