Cruise Control Servo: Service and Repair

1. Disconnect speed control actuator cable from accelerator cable bracket and/or intake manifold support bracket.
2. Disconnect speed control actuator cable with adjuster from accelerator cable.
3. Remove two vacuum hoses and electrical connector from servo assembly.
4. Remove two nuts holding servo to mounting bracket.
5. Carefully remove servo and cable assembly.
6. Remove two nuts holding cable cover to servo.
7. Pull off cover, then remove cable assembly.
8. Attach cable to servo.
9. Attach cable cover to servo with two nuts.
10. Attach servo to mounting bracket.
11. Feed actuator cable under air cleaner duct.
12. Snap actuator cable with adjuster onto accelerator cable.
13. Connect actuator cable to accelerator cable bracket and install push pin.
14. Install two vacuum hoses and electrical connector at servo.