Ignition Coil: Service and Repair

REMOVAL
1. Disconnect engine control sensor wiring connector from ignition coil and radio ignition interference capacitor.
2. Disconnect secondary ignition wire from coil.
3. Remove ignition coil to ignition coil mounting bracket retaining screws and remove coil.

INSTALLATION
1. Install ignition coil and retaining screws.
2. Tighten screws to 25-35 lb. in. (2.8-4.0 Nm).
3. Install secondary ignition coil wire.
4. Connect engine control sensor wiring connector from ignition coil and radio ignition interference capacitor.