With Floor Shift

NOTE: The transmission shift linkage adjustments must be performed in the order in which they appear.

1. Position the selector lever in the OVERDRIVE position against the rearward stop. The floor shift lever must be held in the rearward position using a constant force of 1.4 kg (3 lb) while the linkage is being adjusted.
2. Loosen the manual lever-to-control cable retaining nut.
3. Move the transaxle manual lever to the OVERDRIVE position, the second detent from the most rearward position.
4. Tighten the retaining nut to 17-23 Nm (12.5-17 ft lb).
5. Check the operation of the transaxle in each selector lever position. Ensure that the park mechanism and the park/neutral position switch are functioning properly.