E2 Check Valve Coil

- Disconnect 8-pin valve block connector.

- Verify terminals on both halves of the 8-way connector are clean and secure.

- Measure resistance between Pins 1 and 6 and Pins 4 and 6 on the valve block.

- Are both readings between 5 and 8 ohms?

YES -- Remove main relay. Service open or short to ground in circuits 495 (T) and 532 (O/Y) between valve block harness connector and anti-lock brake control module connector. Install relay. Go to E4. E4 Check For DTC Repeatability

NO -- Replace HCU. Go to E4. E4 Check For DTC Repeatability