With A/C

Removal








1. Disconnect battery ground cable.

2. Remove radio.

3. Gently pull the finish panel away from the instrument panel, and cluster. The finish panel pops straight back for approximately one inch, then "up" to remove. Take care so as not to wrap the finish panel around the steering column. If the vehicle is equipped with the electronic 4x4 electronic shift control, disconnect the wire from the rear of the 4x4 electronic shift control switch before trying to remove the finish panel from the instrument panel.

4. Remove the four screws attaching the A/C control to the instrument panel.

5. Pull the A/C control through the opening far enough to allow removal of electrical connections from heater blower motor switch and control lamp socket and wire. Working with a small screwdriver, remove the A/C plenum vacuum harness harness from the vacuum switch which is part of the A/C control.

6. Remove the A/C control from the instrument panel.

For installation, follow removal procedures in reverse order.