Electronic Climate Control Module

Control Assembly

Removal

1. Disconnect battery ground cable.

2. Remove the cigarette lighter and range selector knob (if applicable).

3. Remove the two screws directly above the A/C control retaining the instrument panel finish panel to the instrument panel.

4. Remove four screws retaining control assembly. Pull control assembly away from instrument panel into a position which provides access to rear connections.

5. Disconnect two harness connectors from control assembly by depressing latches at top of connectors and pulling.

6. Remove nuts retaining vacuum harness to control assembly. Remove control assembly from instrument panel.

Installation

1. Connect two electrical harness connectors to control assembly. Push keyed connectors in until a click is heard.

2. Attach vacuum harness to vacuum port assembly. Secure harness by tightening two nuts.

3. Position control assembly into instrument panel opening and install four screws. Ensure that, as control is positioned, locating posts are correctly aligned with their respective holes. Tighten screws to 2-3 N.m (18-27 lb-in).

4. Carefully place instrument panel finish panel into its assembly position and secure with two screws. Tighten to 2-3 N.m (18-27 lb-in).

5. Connect battery ground cable and check system operation.