System Deactivation Procedures

1. Disconnect positive battery cable.
2. Wait one minute. This is the time required for backup power supply in air bag diagnostic monitor to deplete its stored energy.
3. Remove two back cover plugs and remove screw and washer assemblies retaining driver side air bag module to steering wheel. Disconnect driver air bag connector. Remove driver side air bag module from vehicle.

WARNING: PLACE AIR BAG MODULE ON BENCH WITH TRIM COVER FACING UP.




4. Connect Rotunda Air Bag Simulator 105-00010 or equivalent to vehicle harness at top of steering column.
5. Remove passenger side air bag module. Install Rotunda Air Bag Simulator 105-00010 or equivalent on vehicle harness connector in place of passenger side air bag module.
6. Reconnect positive battery cable.