System Reactivation Procedures

1. Disconnect positive battery cable.

WARNING: THE AIR BAG SIMULATOR MUST BE REMOVED AND THE AIR BAG RECONNECTED WHEN THE SYSTEM IS REACTIVATED.

2. Wait one minute for backup power supply in air bag diagnostic monitor to deplete stored energy.
3. Remove Rotunda Air Bag Simulator 105-00010 or equivalent from vehicle harness connector at top of steering column.
4. Reconnect driver side air bag module.
5. Position driver side air bag module on steering wheel and secure with two screw and washer assemblies (8mm). Tighten screw and washer assemblies to 10.2-13.8 N-m (8-10 lb-ft). Install two back cover plugs.
6. Remove air bag simulator from vehicle harness connector on passenger side. Reconnect and install passenger side air bag module.
7. Reconnect positive battery cable.
8. Prove out system.