T2 Service Connector/Terminal Fault

- Most likely problem is at one of the affected component connectors such that terminals unseat or back out upon installation. At each affected connection, look for:

- damaged connector terminal locks.

- damaged connector wedge.

NOTE: If one of the above conditions is found, check the length of the affected circuit once the connection is remade. If the wire is too tight (short), damage is likely to recur once vehicle is given back to the customer. Service the wire as necessary to correct tight wire conditions.

- Are any of the above conditions noted?

YES -- Service connector and terminal as necessary. Go to T7. T7 Verify Condition Resolved

NO -- Go to T6. T6 Verify All Appropriate Diagnostic Procedures Have Been Run