Parts Replacement Notes

NOTE: The various major assemblies in the supplemental air bag restraint system have been designed to be tamper-resistant and are not to be disassembled for service. Component assemblies may be removed and replaced as required by diagnosis and testing.

NOTE: Original parts should be reinstalled in the vehicle if replacement parts have no effect on the repair.

CAUTION: Before attempting diagnostic prove out, check all sensors and wiring for damage or shorts that could cause the air bag diagnostic monitor thermal fuse to blow (open), causing unnecessary replacement.

After all service is completed, verify the air bag indicator operation as follows:
^ Turn the ignition switch to the RUN position.
^ If the indicator flashes, count the air bag indicator flashes only after the code (series of flashes) has cycled twice.
^ If the air bag indicator illuminates continuously for four to eight seconds and then goes out, the supplemental air bag restraint system is functioning properly and all faults have been serviced. If the air bag indicator does not illuminate or remains continuously illuminated, there is a malfunction in the system. Refer to Pinpoint Test N or Pinpoint Test C in Diagnosis and Testing.